So first time out on the new crim to QR and under load it won't rev past 8.5k
It seemed ok for the first lap or so but then it just wouldn't pull past 8.5 grand. There was no real popping or banging like it was lean it was just really flat. Getting off the throttle back below 8.5 and it seemed to run fine.
In the three sessions I got in before throwing it down the road (another story) I tried a different map on the pc3, checked the fuel lines and breathers for kinks, checked all the electrical connections under the tank and eventually removed the over all with no improvement. It will rev fine in neutral on the stand or with the clutch pulled when coasting.
The bike is not registered so any fault finding will be on a dyno, so I'm looking for ideas to check before forking out cash.
Im going to have a bit of time up my sleeve to check things while my ankles recover