Thought i'd post a little comment on where it's at.............GOING ABSOLUTELY NO WHERE!!!!
This all happened a little while ago I was examining the 2nd frame from all angles. It didn't look good. I found an engine mount (tube running through the frame near the front) that initially appeared to have been re-welded in but then it became obvious the weld went right around the frame tube. SHIT. Another frame weld was found near the bottom frame on the same length of tube. Also noticed that right down at the last 20 cms of the rear the subframe has been re-welded. Has this thing been completely busted up?
Looking at the frame again it appears the main tube at the top of the fairing looks like it's bending off to the right hand side. I put a straight edge on it to confirm, yep, bent. Re-examine a third time and now the bent frame is unbelievably obvious to me.
So i'm left with two munted frames. One with a good main frame but shit subframe, and one with a shit main frame and half decent, but not perfect subframe. A blending of the two may be required. This is not likely to happen any time soon. I might take some pics and post them up tomorrow.
And that is where it's at.