zrx 1200r lacking fuel issues

gday, have just installed the kwik +4 degree and also a K&N #2990 pod filter on my 2008 zrx1200r, and in doing this is causing a lack of fuel problem, i have a new carbie recalibration kit and am just wondering what settings are required to overcome this problem.

The jets supplied in the kit are (2 of each) 128,130,132,135.

The bike will pull until it reaches 5000 revs.

Does the kit not come with instructions or a base setting? My one did and I put that in and have not changed a thing since, except going from stock to +2 then the ELS +4

What pipe do you have? Full system or slip on?

Yes it came with some instructions i have found now,130 out 132 in needle clip 3rd slot downfuel screws 2 turns out. Also i have a scorpion slip on exhaust.

Yes it came with some instructions i have found now,130 out 132 in needle clip 3rd slot downfuel screws 2 turns out. Also i have a scorpion slip on exhaust.

I'd use that a starting point and adjust as necessary.

thanks for your help just took the bike out for a test ride and is running perfect, we ran 130 outers and 132 inners. 3rd clip down 2.5 turns out.

Farmer - have you sorted out the old Z1000H yet ?

Mate. running like a Collingwood Rover! Getting ready to ride to Broadford.
Now I'm working on my Mark 2. That was my back up plan for Riddles creek but after I got the H running I went a bit slow on it. The zrx is the boy racer's.

The zrx is the boy racer's.

effing big boy!

Mate. running like a Collingwood Rover! Getting ready to ride to Broadford.
Now I'm working on my Mark 2. That was my back up plan for Riddles creek but after I got the H running I went a bit slow on it. The zrx is the boy racer's.

Cool good to hear another H is on the road where it belongs....