frl0173 wrote:First place to check would be the crank case breather, check to make sure the hose isn't blocked and is still contected. After that check your oil filter another club member had a oil filter seal blow at PI last year. Other than that start checking for holes in the block
If othing is obvious pull off the fairing and degrease everything, top up the oil to the level it should be and start the bike and start looking for where it may be coming from.
Good luck.
greenmeanie wrote:Clutch push rod seal........that's what i reckon it is.
Left hand side.....cheap fix if it is that as i had the same problem with my 7 several weeks back. It will appear you have lost a lot of oil but it is really bugger all just leaves a big mess though.
The seal comes out of its little slot it sits in when it gets older hence the oil leak. Replace it with a new seal add a little silicone to help it hold in better and your away.
If your not sure take it to a bike mechanic, seal will cost you about $7 and your in & out in 1/2 hr tops.
P.S - Leave your fairings off & make sure you wash down that back tyre. I just used some warm water + a bit of detergent then gave the whole rear of the bike a good blast.
Good luck with it.
the kid wrote:Good work Greenie
Kwakka Kilt wrote:the kid wrote:Good work Greenie
+1 Kuda for the Greenie !!
Return to ZX-R Older Model Discussion
Users browsing this forum: No registered users and 16 guests