Just noticed that my ZX7r was a little hard to move around , I put the front wheel up and sure enough it was very hard to turn. My first thought was to check the axle bolt wasn't over tightened , backed it right off and still firm. So I then looked at callipers removed them and she spins effortlessly !
So my questions are ;
If the pistons look free of corrosion do you still need to replace ? I am thinking I should be able to clean up and just
Buy a seal kit as they look a little worse for wear and assume they are swelled up and causing piston not to return .
Is there any good suppliers over here in Aus or do I buy on ebay overseas or go genuine ??
Has anyone had any issues do similar rebuild ... Any do's or don'ts ???
Advise would be greatly appreciated.
Thanks in advance