Discussion area for Moto GP, WSB, WSS and national racing - non Kawi related
Thu Apr 11, 2013 9:33 pm
Steve its the OEM..... I am trying to track down some AP Lockheed dual piston's as I have a bigger cast disk that came with the Akra rims, I would only need to fabricate a bracket.
Thu Apr 11, 2013 9:44 pm
That would be the go I have a single grimeca on my tz350 with a half inch mastercylinder and it stops on a dime
Thu Apr 11, 2013 9:50 pm
robracer wrote:.....Steve its the OEM..... I am trying to track down some AP Lockheed dual piston's as I have a bigger cast disk that came with the Akra rims, I would only need to fabricate a bracket.......
the aussie distributor for AP Lockheed lives about 30km away from me mate - if you want a 4-fin AP let me know. Pretty sure these are OK for P4 ??
Fri Apr 12, 2013 5:33 am
Gos that would be great if you could shoot over some details, pm sent
Fri Apr 12, 2013 6:58 am
I just ordered a twin piston Grimeca for the LC and a 298mm disc just turned up in the post yesterday to convert it to a single disc like Steve's TZ. The Grimeca was under $200 delivered with pads, where as the only AP Lockheed I found was $257 without pads. I wish I knew you had contacts Gos, as I would have preferred the AP Lockheed if I could get it at a reasonable cost.
Fri Apr 12, 2013 8:57 am
Far canal, you're not holding back are you Nelso?!
Fri Apr 12, 2013 9:07 am
MickLC wrote:Far canal, you're not holding back are you Nelso?!
I need it to stop.
Truth is, I broke one of the LCs calipers and decided it was worth upgrading rather than spending money on more shitty brakes. Thanks to Stevo already having a bracket and spacer that I could copy, it made it a simple conversion.
I had more than one mounting bracket and spacer cut out if you are ever interested in doing the same upgrade.
Fri Apr 12, 2013 9:45 am
Thanks for the offer Nelso, I might have a chat to you about that at round 1.
I'm not so worried about the power of the brakes, but the twin disk setup is pretty bloody heavy so it would be good to dump it.
Fri Apr 12, 2013 6:29 pm
Nelso wrote:...... I wish I knew you had contacts Gos.....
you need to read more of my posts in the Old Dungers section mate !
got 'em by the truckload
Mon Jun 10, 2013 8:49 am
Gos Still looking for one but as per my message the 350 4 runs a 4mm disk
Tue Jun 11, 2013 8:34 am
Well done it again, as the bug has bitten hard...... PC race bike #2 is currently being built up...... progress so far:
- Attachments
-
-
Tue Jun 11, 2013 9:13 am
Mmmmm
That's more my size
Tue Jun 11, 2013 9:13 am
I'd even buy a blue helmet to match
Tue Jun 11, 2013 12:18 pm
Wattie wrote:Mmmmm
That's more my size
Sell the Gumby and go PCRA racing then.
Sun Jun 16, 2013 12:01 pm
Powered by phpBB © phpBB Group.
phpBB Mobile / SEO by Artodia.