Kawasaki Sportsbike Riders Club - Australia - Online Forum
Australian Kawasaki Sportsbike Riders Discussion Forum - All Welcome, free and easy to join, just click "register" below - www.ksrc-au.com
FRIDGE MECHANIC
18 posts
• Page 2 of 2 • 1, 2
Re: FRIDGE MECHANIC
by StuMiller » Thu Nov 15, 2012 8:50 pm
If you can get some R12, get me some too so I can bury it an make a fortune later!
2007 ZX6 - Road bike
-
StuMiller - KSRC Contributor
- Posts: 1360
- Joined: Thu Jun 22, 2006 12:02 pm
- Location: Hobart, Tasmania
- Bike: ZX6R
- State: Tasmania
Re: FRIDGE MECHANIC
by Jonnymac » Thu Nov 15, 2012 10:03 pm
Ok sounds like it shouldn't be too difficult to solder then.
Make sure you clean the area right up with emery paper so it looks like brand new copper before you attempt to weld it up,don't breath in the smoke that will come off it. There will be refrigerant still trapped in the oil in the system and as it heats up it will boil it off and create a toxic smell.
Good luck with the R12
Let me know how it goes.
Make sure you clean the area right up with emery paper so it looks like brand new copper before you attempt to weld it up,don't breath in the smoke that will come off it. There will be refrigerant still trapped in the oil in the system and as it heats up it will boil it off and create a toxic smell.
Good luck with the R12
Let me know how it goes.
-
Jonnymac - KSRC Contributor
- Posts: 1165
- Joined: Thu Jun 16, 2011 1:33 pm
- Bike: ZX6R
- State: Victoria
Re: FRIDGE MECHANIC
by Jonnymac » Tue Nov 27, 2012 9:53 pm
Hey Gos how's your old sticker cabinet going?
-
Jonnymac - KSRC Contributor
- Posts: 1165
- Joined: Thu Jun 16, 2011 1:33 pm
- Bike: ZX6R
- State: Victoria
18 posts
• Page 2 of 2 • 1, 2
Return to Off Topic Discussion
Who is online
Users browsing this forum: No registered users and 28 guests