Angry Emmet wrote:aggerz wrote:Thanks for the help all. I agree the seats appear to just be refaced than replaced.
I pulled the head back off again tonight, going to take it down to an engine builder mate see if he can help measure up a few things for me.
Few pics attached FYI.
I noticed that all the Exhaust valve stem protrude a noticeably past the retrainers whereas the Intake stems not much at all (All Exhaust valves are brand new)QUOTE
Cant see your pictures. BUT, here is a tip, MAKE SURE you get the correct tolerances to your mate to measure, I can dig thme up if you dont have a manual. YOu may not necessarily have needed new seats BUT if their old it is best. Now, the valve stem can be ground down until just above top of collets, you can even take some off the collets BUT you need to be aware the bucket sits correctly pushing on stem and not on the spring cap, pushing on the cap can be a disaster...Depending on your seats you WILL need to take some off the collets after you take some off the stems to get within the height specs. LET ME KNOW if you need the measure, i meant to get it on here but forgot again....MRI will do that to you apparently !!!
A.E.
[/quote]Strika wrote:[quote="Angry .
Return to Classic Kawi Discussion
Users browsing this forum: No registered users and 23 guests