Kawasaki Sportsbike Riders Club - Australia - Online Forum

Does anyone there know a good slave cylinder to use on a hyd clutch conversion on my 9, i will be using a rex master cylinder
which will match the one i have on the front brake.
regards Neale.

do you paint the stripes or use decals

Thanks for the advice i know a good fitter and turner so might get him to look at it.

Hi all I need to renew the unitrac linkage bearings in my missus,s 85 gpz 750 and are hoping someone might know a good alternative to needle roller and bush setup.

Regards Neale.

yeah thanks guys i think i will give one a go,ive dealt with kwick before myself when i got his great little
starter chain tensioner fix and agree he does know his shit.

thanks again Neale

Hi all

Can anyone give me the drum on the ELS ignition advancers , iv,e been thing of getting one for a while but want to be sure its the right thing for my Rex, what are the pros and cons i suppose is the question i,m asking.
My Rex is basicly stock except Remus slipon can and Factory pro stage 3 ...

Thanks Guys

Iv,e just ordered one them thingys from kwick over there in the states should be all good again
after that.
Long live the mighty Rex.

Does anyone know how to rectify the problem of the starter chain tensioner from hitting the clutch basket?
mine is doing it at 20,000 kms, i havn,t yet pulled it apart for a look, i,m assuming it is only happening when
starter is engaged, any help will be greatly appreciated.
Neale.

Ive got a factory pro kit in my zrex1200 with the rear of airbox removed and a big pod type filter (stage 3 kit),
130mains on the two inner cyls 128 on outer cyls needles on 4th clip, 38 pilot jets as per instructions on
jet kit only other mod is remus pipe, it has been checked on dyno and all good ...

thanks phil

i don,t really want to lose any of that low down grunt so i looks like a standard grind would be the best thing then have you had the same problem with yours?

Neale.

they have started pitting that,s why i,m asking if the zzr1200 cams fit i,m not so sure if the 1100 ones do as i know that zrx1100 cams dont fit the zrx 1200

can anyone give me the best option for replacing the zrx12 cams that are prone to pitting?
i have read zzr1200 cams bolt straight pin,can any one confirm this for me?
this is the only fault i,ve found on an otherwise great bike that has only 18000 ks on the clock.