Kawasaki Sportsbike Riders Club - Australia - Online Forum

I bought a puig screen off ebay for my Z750.It looks the goods but i have a couple of questions.
1st is,the fitting instructions are in french,so means nothing to me,although i pretty much get the jist of how to fit,but in the kit there is two little clear plastic nipples with adhesive on the backside of them.
Are these to be used as spacing between the screen and the cowling?
2nd question is,i think the screen is a bit too high and looks gorky,what i want to do is cut about 3'' of the top of the screen.What is the best way to cut it without stuffing it up or cracking it?I was thinking a disc grinder?
Any suggestions????

Post some pics of it first.....

I hope you mean a Dremel or summat like ?
I just got these visions of ya attacking it with a 9" disc

3" off the top fark whaddya buy one for a Beemer ?

Rossi wrote:I hope you mean a Dremel or summat like ?
I just got these visions of ya attacking it with a 9" disc

3" off the top fark whaddya buy one for a Beemer ?

Actually i was thinking my 4" grinder,im not that rough.
Well maybe not 3",but probably at least 2",it just looks way too tall as it is.

So no one else has any clues on this?????
Hmmmm,seems i have to get in contact with a fairing screen manufacturer to see how they cut them?

i speak french fluently when i hit my thumb with a hammer if that any help to ya!