Page 1 of 1
Modified fender
Posted: Wed Jun 20, 2007 9:55 pm
by Technik
I note some of the early ZX-636 models have slight shorter rear fenders, are they standard or modified?
What are the best ways of cutting it?
Cheers
Leon
Re: Modified fender
Posted: Wed Jun 20, 2007 10:17 pm
by Neka79
on other bikes i have cut them with a hacksaw....best option tho is to get an undertail on a model like this... that way u can keep the stock one in case u sell or get hassled by cops...depends how cheap u are!!
Re: Modified fender
Posted: Thu Jun 21, 2007 9:30 pm
by Burky
E-bay fender eliminator, bolt on bolt off if the boy's in blue give you a hard time!!!!
If you saw it off and get hasseled it could be expensive.
Re: Modified fender
Posted: Thu Jun 21, 2007 9:57 pm
by Technik
thanks for the advice guys.
found this fender eliminator kits from ebay, what do you think? (quite similar to the Competition Werkes Fender Eliminator, but at a fraction of the cost!)
http://cgi.ebay.com/ebaymotors/kawasaki ... QQtcZphoto
Re: Modified fender
Posted: Thu Jun 21, 2007 10:41 pm
by Neka79
looks good....but its like the one i have...on ur model, without the undertail it will look shitty with the black plastic....
have a look up under ur wheel...now imagine the fender not there....
Re: Modified fender
Posted: Thu Jun 21, 2007 10:52 pm
by hoffy
mate cut it....its only plastic, it will cut with a stanley knife. Just draw a line first so you know where you are cutting !
Re: Modified fender
Posted: Fri Jun 22, 2007 9:45 am
by red_dave
The easiest thing to do is mount cut a straight line just under the indicators and mount the number plate on the same bracket but using the bottom holes of the plate.
Well, thats what i did when i had that model bike...
Re: Modified fender
Posted: Fri Jun 22, 2007 10:19 pm
by Nanna10r
One point and $80 fine up here in Bjelkie Republic.
Cut the sucker with an thin wheel in an angle grinder, Space the number plate to the right angle.