Tyre Sizes

chameleon · Post by **chameleon** » Wed Feb 01, 2006 11:12 pm

goanna_38 wrote:Everyone else seems to be putting in their 2 cents worth in about Pilot Powers, so here's mine. Had a set on a ZZR1100. Stuck like s#*t to a blanket, tipped in well, got reasonable k's (part commuting, part fanging) and felt good all round except for one thing. Get within about 500 metres of the back end of a truck on the highway and it would start to wander and shift all over the shop. Checked and changed tyre pressure, checked steering head/wheel/swingarms bearings, replaced rear wheel bearings (the only ones a bit suspect and even then not too bad) and it all made no difference. Put a set of 012ss Bridgestones on and all the wandering was a thing of the past. Might be okay on a lighter bike, might even be good on a different ZZR, dunno.

yes they love corners don't they, but down the straight road, truck or no truck, the bike is constantly moving off line "looking for a corner?" There too sensitive for my cruzy style of riding, I'll try something else next time too I think.

Post by **Wattie** » Thu Feb 02, 2006 8:54 am

took the Z for a spin to try out the bt20, at 1st i nearly fell off it, coz it fell into the corners... hehe alot rounder shape me thinks, and felt a little funny at the front so i now have
36psi on front BT019
39psi in rear BT020
and seems ok at the mo, havent done any serious corners yet.
any help on the psi's is welcome

Gosling1 · Post by **Gosling1** » Thu Feb 02, 2006 5:26 pm

Wattie wrote:....any help on the psi's is welcome

what does your manual recommend ??

Post by **Wattie** » Thu Feb 02, 2006 5:53 pm

34 and 42, but 42 feels like too much in the back, squirmy...

greenmeanie · Post by **greenmeanie** » Thu Feb 02, 2006 6:00 pm

33/36

Post by **Wattie** » Thu Feb 02, 2006 6:15 pm

greenmeanie wrote:33/36

interesting, might give this a go next couple of days

just wound up the suspension pre-load, as stock its waaaay to soft....

Gosling1 · Post by **Gosling1** » Thu Feb 02, 2006 6:55 pm

Yep, try them out for a couple of days, those pressures are a good point to start with.

42 in the rear

thats way too hard.........

Strika · Post by **Strika** » Thu Feb 02, 2006 7:52 pm

Depending on what type of rider you are ,and where you ride or what you use it for. If it is to thrash thru the twisties on a Sunday, and your not too worried about tyre life, i would run them a little close to 30 front and rear, and if you need some life go to 32/34..... These are the pressures I used to run on GPX's and ZZR's.

Gosling1 · Post by **Gosling1** » Thu Feb 02, 2006 8:12 pm

on my old Zed I used to run 28/30 !! some guys were even lower..........

but that was strictly for 6-8 laps only, with 2 sighting laps.......

greenmeanie · Post by **greenmeanie** » Sat Feb 04, 2006 8:00 pm

Scrubbed in the tyres out @ Advancetown(Gold Coast Hinterland) this afternoon.

As per usual the pilot race rear really hooked up nicely!

The soft shinko front held the corners nicely(plenty of grip)........wasn't a full on fang @ warp factor 10 as i was only wearing my draggin cargo's & a leather jacket but so far i am happy with the outcome.

Further testing to come.....stay tuned!

Nanna10r · Post by **Nanna10r** » Sun Feb 05, 2006 12:15 am

The Shinko Stealth 003 ULTRA Soft REARS will be here in time for winter. Special order only 200 being made. Half to Goodna half to a bloke in Vic, the same deal as with the fronts. Cant wait me.
Sounds good Glenn i scrubbed mine week befor last on the Bellbird Park Raceway. Bounced & backed it into a coupla hairpins but thats just getting used to the higher pressure the 003 prefers.
They are'nt pilot race/metzler racetech but better then the rest of the stuff out there. imho.
Cheers Brett

greenmeanie · Post by **greenmeanie** » Mon Feb 13, 2006 7:44 pm

Well after doing 1200 kms over the last 2 days on the soft shinko front/pilot race rear combo i would have to give them a big thumps up.

Plenty of grip both in the wet,dry and semi dry(damp patches) conditions through twisties @ a "spirited pace".

Nanna10r · Post by **Nanna10r** » Wed Feb 15, 2006 2:15 am

Hows the wear rate glenn ?.
Cheers Brett

greenmeanie · Post by **greenmeanie** » Thu Feb 16, 2006 5:27 am

Wear rate is good, they don't look that used all things considering which is great for a soft tyre. No problems pushing the front from edge to edge...plenty of confidence with the front end grip which is what i wanted.

Jonno · Post by **Jonno** » Sat Feb 18, 2006 7:00 am

Just wondering if the max' speed rating is still around 230kmph?