clutch q's?

ozx6r · Post by **ozx6r** » Wed Jun 07, 2006 7:00 pm

just did the dedent spring under clutch but when i reinstalled the clutch I was unsure about the flat/rounded side of the metal plates and which way they faced - to me it shouldnt matter because there are friction plates on the outside front to back but is this correct?

also there are to washer at the rear of the basket one flat and other with slight angle - they fell out and i didnt see which order they went!

is it the angle first and then the flat as it has contact with the first friction plat?

thanks in advance...

ozx6r · Post by **ozx6r** » Fri Jun 09, 2006 9:13 pm

must have been right

it changes really well now it was a great update for the dollars!

only prob was the factory pro kit comes with a new gasket that fell apart in my hands and i had to buy another one which was the only real drama of the entire install....

YAPPA · Post by **YAPPA** » Thu Jun 15, 2006 10:40 pm

m8, if in doubt.....remember I've got a manual

good 2 hear its all good