fairing conectors?

ryan12 · Post by **ryan12** » Tue Aug 15, 2006 10:19 am

so i bought this 1998 zx7r and it is customed out with a nice paint job ect ect but my problem is i believe one side faring is aftermarket because both sides dont come together on underbody. the two faings dont join. i was wondering if there are any conectors or how do stock fairings conect? ithink if they connected it would look so much better please help me

Duane · Post by **Duane** » Tue Aug 15, 2006 10:29 am

The two fairings connect at the very back of the fairing, theres a clip built into them, theres also a screw at the very front that joins the two peices of fairing together.

Post by **MadKaw** » Tue Aug 15, 2006 10:36 am

There is a small fairing connector at the front that sits inside the 2 side fairings.
At the rear, in front of the back wheel, the fairings overlap each other and have a couple of tags to hook them together.

Duane · Post by **Duane** » Tue Aug 15, 2006 10:42 am

What year did you have Dave?? Mine only had the screw at the front, and the clip which joined the two peices of fairing (aka a hole in one, and a lump on the other)

Post by **MadKaw** » Tue Aug 15, 2006 11:06 am

Mine was a 96 but they are all the same.
The bit I'm referring too is 55028 as per pic.

Duane · Post by **Duane** » Tue Aug 15, 2006 4:27 pm

thats alright thats the connector tab at the back, phew!

ryan12 · Post by **ryan12** » Wed Aug 16, 2006 5:31 am

ok so do u know u if u can get connectors?

Duane · Post by **Duane** » Wed Aug 16, 2006 10:05 am

the connectors are built into the fairings (they overlap).

If you can find a part number for something you need, just give Cosways or BK a call, you'll be fine (unless you're not in victoria)