how do i take my front seat off?

Poyda · Post by **Poyda** » Mon Jan 29, 2007 11:40 am

Maybe you could give this a go after the pry bar, large screw driver, FB hammer and finally the grinder

MickLC · Post by **MickLC** » Mon Jan 29, 2007 12:05 pm

These might do it...

hidepenny · Post by **hidepenny** » Mon Jan 29, 2007 12:29 pm

this is a Chaos!!!!!

Duane · Post by **Duane** » Mon Jan 29, 2007 12:57 pm

no hi depenny

this is ridiculous

hidepenny · Post by **hidepenny** » Mon Jan 29, 2007 1:01 pm

What more have you people got?? huh??? come on bring it on!!!!!!

Daisy · Post by **Daisy** » Mon Jan 29, 2007 1:03 pm

hidepenny wrote:What more have you people got?? huh??? come on bring it on!!!!!!

What! All the helpful advice you've got so far, and even with all the heavy machinery, you still haven't got your bike off that seat?

mrmina · Post by **mrmina** » Mon Jan 29, 2007 4:07 pm

some people would be so greatful with this amount of advice

hidepenny · Post by **hidepenny** » Mon Jan 29, 2007 4:14 pm

some people would be so greatful with this amount of advice

i'm too with some many advanced advises that not even normal ppl can think of

Duane · Post by **Duane** » Mon Jan 29, 2007 4:24 pm

Seat removal for most bikes

1. Insert key into boot lock
2. Turn key
3. Lift pillion seat (not the one you're trying to take off)
4. Put pillion seat on floor, or table depending on furnishings available
5. have a 'fiddle' (thanks neka)
6. Now, most ive seen is the following methods,

there is either a pull wire (a loop made of wire you pull, which detaches the front seat);
there is one bolt in the middle at the very front of where the pillion seat used to be.
there is two bolts, one on the left, one on the right of the very front where the pillion seat used to be
also, my spewzuki had allen key bolts at the front of the riders seat hidden by the apolstry you had to lift up.

Once you've figured out which one it is, if there are anymore, i'd would say i'd be interested to know, but really, its not that interesting
7. remove bolts
8. place bolts somewhere near pillion seat
9. remove front seat (this may feel like its not going to happen the first time, but trust me
10. put seat near pillion seat and bolts if they have been required to be removed.
11. have a fiddle
12. Stand and admire battery, if present
13. replace in reverse order.
14. have a fiddle

Neka79 · Post by **Neka79** » Mon Jan 29, 2007 6:59 pm

ok mate...since were all giving u a hard time ill be serious for a minute...

1.open rear seat
2.take out tool kit.
3.find correct size hex/allan key or screw driver.
4.insert in ur arse.
5.bounce up and down until it feels good.
6.take out aforementioned tool
7.sniff aforementioned tool.
8.ask sensible questions...

ttc · Post by **ttc** » Mon Jan 29, 2007 8:35 pm

i told him how to take the seat off, its bloody obvious once you take the cowl off and look under the riders seat.. one bolt and it clips on at the front..

but carry on children

Neka79 · Post by **Neka79** » Mon Jan 29, 2007 9:32 pm

ttc wrote:i told him how to take the seat off, its bloody obvious once you take the cowl off and look under the riders seat.. one bolt and it clips on at the front..

but carry on children

carn Tan..this is MUCH more fun....

FrogZ · Post by **FrogZ** » Tue Jan 30, 2007 6:22 am

I was with you right up to the sniffing part, thats just taking it TOO far

shadowzx9 · Post by **shadowzx9** » Tue Jan 30, 2007 7:16 am

Its only a ZX6.... Stick of dynamite should solve all your problems

mick_dundee · Post by **mick_dundee** » Tue Jan 30, 2007 7:28 am

Jackhammer had a mention yet? Got the big track mounted ones across the road at the Kodak factory, i'll ask if I can borrow one if ya like HP