Just needed to get that out of my system.
$100 bit of plastic
- Aussie Ninja
- KSRC Regular

- Posts: 833
- Joined: Mon Nov 15, 2004 8:00 am
- Bike: ZX10R
- State: New South Wales
- Location: Eastern Creek
$100 bit of plastic
Bugger Bugger Bugger Bugger Bugger Bugger Bugger
While fitting the last of my four needles for my jet kit I broke a little retaining tang in the slider writing off the whole thing.
Replacement cost $98. So my poor baby is in bits till next Friday. Did I mention Bugger?
Just needed to get that out of my system.
Just needed to get that out of my system.
Real bravery is being afraid but doing it anyway.
1998 ZX6R R.I.P.
2004 ZX10R killed by Roo.
2011 ZX10R
1998 ZX6R R.I.P.
2004 ZX10R killed by Roo.
2011 ZX10R
- ZX-10R_04
- KSRC Regular

- Posts: 762
- Joined: Wed Aug 11, 2004 11:18 pm
- Bike: ZX10R
- State: Tasmania
- Location: Launceston Tasmania
- Contact:
re: $100 bit of plastic
If It Aint A Lime It Must Be A Lemon !!!!
04 ZX10R & 08 ZX10R
04 ZX10R & 08 ZX10R
re: $100 bit of plastic
Little bloody obscure frucker, they can get expensive.
"The road to hell is paved with good intentions" screw it then i'll just be bad.

- Aussie Ninja
- KSRC Regular

- Posts: 833
- Joined: Mon Nov 15, 2004 8:00 am
- Bike: ZX10R
- State: New South Wales
- Location: Eastern Creek
re: $100 bit of plastic
Well I got my new slider, chucked her back together and went for a run to the coast and back. That jet kit really did the trick.
Its got more everywhere. The mid range has been filled nicely and once that needle hits 9.
She just kept pulling to redline, right through the higher gears. 
Real bravery is being afraid but doing it anyway.
1998 ZX6R R.I.P.
2004 ZX10R killed by Roo.
2011 ZX10R
1998 ZX6R R.I.P.
2004 ZX10R killed by Roo.
2011 ZX10R
