Remove primary sprocket cover-ZZR1100

ZZR 250, 600, 1100 & 1200
Post Reply
User avatar
kwakkadakka
Warming up
Warming up
Posts: 46
Joined: Tue Mar 03, 2009 5:26 pm
Bike: ZZR1100
State: New South Wales
Location: Northmead, Sydney.

Remove primary sprocket cover-ZZR1100

Post by kwakkadakka »

OK, I've never owned a bike with a hydraulic clutch before :? The manual says to "remove the slave cylinder,push the piston back as far as it will go, depress the clutch lever and put a band around it (this stops the slave piston from popping out)." I just want to clean the gunk out of the primary sprocket area. Pushing the clutch lever with the slave cylinder free was the LAST thing I would normally have thought to do. Is this correct?? :? :? I don't want to pop the piston. Anyone done this, please??? :? :?
Top
User avatar
seiko1
Apprentice Post Whore :-)
Apprentice Post Whore :-)
Posts: 7643
Joined: Wed Jan 14, 2009 8:36 pm
Bike: ZX14R
State: Victoria
Location: Geelong

Re: Remove primary sprocket cover-ZZR1100

Post by seiko1 »

I have a ZZR and depressing the lever while the slave cylinder is off would be the last bloody thing I would do!
Just put an elastic band over the Piston, if you can be bothered!
For me personally... stuff it, just let it hang :)
Policy - Find something simple.....and Complicate it!
Top
Post Reply

Return to “ZZR Discussion”