install on a zx6r detent kit

ozx6r · Post by **ozx6r** » Wed Jul 13, 2005 8:16 pm

has n e 1 done the install?

looks easy enough from the instruction but thought there may be something to look out 4!

also kit doesnt have bearings as some kits do

should this be changed at same time?

thanks 4 any info

Jonno · Post by **Jonno** » Fri Jul 15, 2005 2:56 am

Detent kit for what may I ask that dumb question, I could guess it being a gear shift setup?

Post by **MadKaw** » Fri Jul 15, 2005 7:36 am

I put a factory pro shift kit and detent arm in the my zx9r.
Its about a 4 beer job with the hardest part getting the clutch basket bolt off. I hired a rattle gun and that solved the problem.
You will need a clutch cover gasket and thats about it.

The one I put in looked like this, but it was before they had the shift star.
The stock detent arm looks like a mini pizza cutter with a rivet holding the 2 pits of metal together. The factory pro one has roller bearings..
One of the best mods I made, eliminated missed shifts and shifts much quicker.

http://www.factorypro.com/images/ShiftK ... FT,H51.jpg

http://www.factorypro.com/Prod_Pages/prodk67.html

and theres an intersting letter on the bottom of the page..

ozx6r · Post by **ozx6r** » Fri Jul 15, 2005 9:33 pm

yeah saw ya letter good work, get n e benefits for that?

after looking closer i noticed at the end of the detent arm it has the bearing i wasnt sure about and the kit has the gasket so it just means i have to get off my lazy arse and install it

thanks dave