jacking up a zx6R

simtur · Post by **simtur** » Mon Aug 08, 2005 1:04 pm

Whats the best way to jack up a 95 zx6r?
i want to take the front end off and hang the frame from the beams in my garage.

stonneville · Post by **stonneville** » Wed Aug 10, 2005 12:27 pm

why the hell would you want to do that

Ride the bugger

spose you could throw a rope (tied to your garage beams) around the bike and haul her up take the forks off that way

Duane · Post by **Duane** » Wed Aug 10, 2005 1:18 pm

stonneville wrote:why the hell would you want to do that Ride the bugger

He's going to put a blue screen behind him, get on the bike and pretend he's poppin monos

mrmina · Post by **mrmina** » Wed Aug 10, 2005 1:38 pm

mate use rope around the triple clamp but take the screen off just incase

Strika · Post by **Strika** » Thu Aug 11, 2005 5:14 pm

Remove the tank and airbox (note pull ot the two plugs on top of the airbox and a 10mm socket goes straight in and undoes the two bolts holding the airbox to the carbs-dont have to undo all the bolts around the outside, leave em)

Remove front fairing

Remove fairing lowers.

Remove ram air pods, otherwise rope will split the pods.

Attach rope thru ram air ducts in frame.

Place trolley or normal jack under motor and lift. Tighten ropes as you go.

This is all assuming you have no hoists or other equipment.

If you have no roof beams to hang it off, pull off all the body work and lay it over on a piece of thick foam on its side.

Good luck hope this helps.