Page 2 of 2
re: Brakes...
Posted: Mon Jun 20, 2005 2:42 am
by Neka79
mate i reckon to check em ur gunna need to pull the discs off the bike...then u can use one of them "true" guage thingies to check it properly...jack up the front end, undo the axl bolt & slide front wheel out & its a matter of 5 min to undo the hex bolts & take disc off...dont forget to support the front end tho....
re: Brakes...
Posted: Mon Jun 20, 2005 2:51 am
by Barrabob
http://www.chaingang.com.au do reco roters for a reasonable price in wave roters if ya need them.
Posted: Tue Jun 21, 2005 9:13 pm
by Androo
change your brake fluid before you think about discs..
my bike vibrated a bit when I bought it, but replacing the disgusting brake fluid pretty much fixed it!!
Posted: Tue Jun 21, 2005 11:33 pm
by mile636
I wish its that simple...
But i might give it a try...
mile636
Posted: Thu Jun 23, 2005 11:06 pm
by Shifty
A service manual would be a good start (to check if you need any special tools for the job, and to tell you if there are any tricks to geting things apart).
You only learn by going outside your comfort zone, so have a read of the manual, get someone along that knows what they're doing, and go for your life.
Note that it will only get worse and the longer you leave it the less likely that machining/straightening will be an option.