Fuel Injection

briffa · Post by **briffa** » Sun Jun 25, 2006 12:56 pm

Hey do any of you guys with Fuel Injection put a cleaner through your engine????
If so then what type and how much?????

Steve_TLS · Post by **Steve_TLS** » Sun Jun 25, 2006 9:55 pm

I have.

Whatever the servo has on the shelf. I hope it doesn't knock the octane rating around too much as I put the whole bottle in, and only do it before a hard ride so the fuel is only in the tank for a few hours. Maybe once sometimes twice a year.

SocialSecurity · Post by **SocialSecurity** » Mon Jun 26, 2006 10:58 am

i think most of those bottles are supposed to be mixed with a ~60 litre tank of fuel

i used a bottle of 'carby cleaner' on my old cbr250, cept would put like a quarter of the bottle in with a full tank... noticed very slight increase in throttle response/smoothness, just like when pulling the carbys down and cleaning them out even when they are not quite 'sumoto' dirty

Stereo · Post by **Stereo** » Mon Jun 26, 2006 12:24 pm

Yeah I have used it.... I had a plug fouling problem a year ago and used it for a while to clear that up...

Must buy another bottle, wouldnt hurt to run one through again...

Burky · Post by **Burky** » Mon Jun 26, 2006 5:25 pm

That is handy to know. Used to Manufactures directions it should be a full tank (60l) lasting at least a full few days, but half a bottle in 20L for 1 day should be more potent

or

either way i will give it a blast.

briffa · Post by **briffa** » Mon Jun 26, 2006 6:02 pm

Ok thanks everyone.
I didn't know what and whether to use the cleaner in a bottle or whether it has to be done at the stealership or whether to take the injectors out to clean it that way.
cheers
Paul

SocialSecurity · Post by **SocialSecurity** » Mon Jun 26, 2006 6:45 pm

if you really have dirty injectors, the only way to properly clean them is by taking them out and having them cleaned

Kawasaki Sportsbike Riders Club - Australia - Online Forum

Fuel Injection

Fuel Injection

Thanks