Friction point adjusment

zxsixr03 · Post by **zxsixr03** » Tue Oct 11, 2011 3:30 pm

How do i adjust where the friction point comes in on the clutch (not the span of the lever) mine is less than a finger width from the bar so each stop light i have use 4 fingers and pull the clutch right to bar to get neutral or a quick stop with the clutch in if not right against the bar the bike creeps a lot....

Post by **MadKaw** » Tue Oct 11, 2011 3:42 pm

Either the big serrated adjuster going into lever mount - wind it out.
Or at the clutch cover theres an adjusting nut and lock nut on the cable down there... you need to adjust it to pull the clutch rod a little more.

zxsixr03 · Post by **zxsixr03** » Tue Oct 11, 2011 3:56 pm

Adjuster at lever just alters the free play in the lever, not actually where the clutch engages, i will try the other end..
Cheers

Post by **robracer** » Tue Oct 11, 2011 4:15 pm

zxsixr03 wrote:Adjuster at lever just alters the free play in the lever, not actually where the clutch engages, i will try the other end..
Cheers

Um yes it alters both freeplay & clutch engagement..... its all relevent, it does the same at both ends

photomike666 · Post by **photomike666** » Tue Oct 11, 2011 7:28 pm

Ky jelly

Kawasaki Sportsbike Riders Club - Australia - Online Forum