brakes squealing

For general Technical and Performance Discussions
User avatar
smek
VIP MEMBER
VIP MEMBER
Posts: 1497
Joined: Fri Jul 02, 2004 12:32 am
Bike: ZX10R
State: New South Wales
Location: Chatswood, Sydney

brakes squealing

Post by smek »

just noticed today that my front brake is squealing a bit .. ya know that classic brake squealing sound.
i put new pads on maybe 500k's ago.

any advice on what's likely to cause it and what i should check ?
Flakey
KSRC Member
KSRC Member
Posts: 184
Joined: Fri Apr 23, 2004 12:46 pm
Location: Perth, West Aus
Contact:

re: brakes squealing

Post by Flakey »

Put some oil on em, that'll quiet them down... Acutally don't... :D

May find the pads might be glazed (depends on how you use them) and need roughing up.

If you don't heat them up enough when riding, then the pads go 'shiney' and make wikud noises... Still work ok tho. 8)

That's my 2c anyway.
Image
User avatar
smek
VIP MEMBER
VIP MEMBER
Posts: 1497
Joined: Fri Jul 02, 2004 12:32 am
Bike: ZX10R
State: New South Wales
Location: Chatswood, Sydney

Re: re: brakes squealing

Post by smek »

Flakey wrote:Put some oil on em, that'll quiet them down... Acutally don't... :D
lol
Flakey wrote: If you don't heat them up enough when riding, then the pads go 'shiney' and make wikud noises... Still work ok tho. 8)
could be a possibility .. did a couple of reefton runs after putting them on but lately its only been commuting.
User avatar
Smitty
VIP MEMBER
VIP MEMBER
Posts: 10912
Joined: Wed Apr 21, 2004 1:59 pm
Bike: ZX12R
State: Victoria
Location: 3rd rock from the Sun
Contact:

Re: brakes squealing

Post by Smitty »

smek wrote:just noticed today that my front brake is squealing a bit .. ya know that classic brake squealing sound. i put new pads on maybe 500k's ago. any advice on what's likely to cause it and what i should check ?
nikos...
glazed pads would be my diagnosis
'glazed'? as in the pad surface gets shiny coz the pads have not been bedded in
fix?
take pads out....find nearest concrete footpath or driveway
rub friction side of pad on concrete to roughen 'em up
(watch knuckles or fingers don't get the same treatment :lol: )
and DON"T breathe in pad dust!
then
get emery paper and rub disk rotor across the disk, NOT round and round...
(and do both sides) where the pads rub
then put pads back in
find quiet street or carpark
go thru 8-10 hard stops (don't lock front brake) from 50kmh down to
10kmh (beds in brake pads)
then go for a ride and use front brake normally
come home and let cool down
problem should be gone


cheers
GOTTA LUV the 12R!!
Felix
KSRC Contributor
KSRC Contributor
Posts: 1173
Joined: Thu Sep 02, 2004 1:54 am
Bike: Suzuki
State: Overseas
Location: Osaka

re: brakes squealing

Post by Felix »

If they are glazed, I am pretty sure there is a paste you can get that you apply to the pads, then just go for a spin. :?: :?: :?:
- Team Furball -

Image
User avatar
Smitty
VIP MEMBER
VIP MEMBER
Posts: 10912
Joined: Wed Apr 21, 2004 1:59 pm
Bike: ZX12R
State: Victoria
Location: 3rd rock from the Sun
Contact:

Re: re: brakes squealing

Post by Smitty »

Felix wrote:If they are glazed, I am pretty sure there is a paste you can get that you apply to the pads, then just go for a spin. :?: :?: :?:
ummm...
toothpaste?? valve paste??? BonAmi??
been doing brakes for 30 years and thats a new one on me.
any more info??? please


cheers
GOTTA LUV the 12R!!
User avatar
smek
VIP MEMBER
VIP MEMBER
Posts: 1497
Joined: Fri Jul 02, 2004 12:32 am
Bike: ZX10R
State: New South Wales
Location: Chatswood, Sydney

re: brakes squealing

Post by smek »

Thanks everyone. you rock :rock:
User avatar
Rossi
KSRC Contributor
KSRC Contributor
Posts: 1656
Joined: Sat May 01, 2004 12:39 am
Bike: ZX9R
State: Victoria
Location: Vic : Epping

Re: re: brakes squealing

Post by Rossi »

Felix wrote:If they are glazed, I am pretty sure there is a paste you can get that you apply to the pads, then just go for a spin. :?: :?: :?:
are you sure that you're not talking about copper paste which goes on the rear of the pad ??
I don't suffer from insanity; I enjoy every minute of it.
Felix
KSRC Contributor
KSRC Contributor
Posts: 1173
Joined: Thu Sep 02, 2004 1:54 am
Bike: Suzuki
State: Overseas
Location: Osaka

re: brakes squealing

Post by Felix »

NFI.

My mech used to have some stuff that he put on the disks/pads of my car...actually two mech's did...buggered if I know what it was...


'member, me'em just bush'canic cuz!!

Flat tyre = kanga-grass in tube...

...and so forth...
- Team Furball -

Image
User avatar
aardvark
Apprentice Post Whore :-)
Apprentice Post Whore :-)
Posts: 5766
Joined: Wed Apr 07, 2004 6:45 pm
Bike: Yamaha
State: South Australia
Location: Adelaide, S.A.
Contact:

re: brakes squealing

Post by aardvark »

My brakes are opposite of that. When I pull them on they feel like they are loose and jumping around all over the place. They also make a grinding noise when I use them.

I have checked calipers etc and everything seems to be ok. I guess that's just the way they are.
User avatar
Nanna10r
Team Ninja
Posts: 4291
Joined: Wed Jul 14, 2004 10:42 pm
Bike: ZX10R
State: Queensland
Location: Brisbane Australia

re: brakes squealing

Post by Nanna10r »

Hey u farllas doen go Fukin wi' Felizx, he alrigh aye, Him top farlla bush canic roun ere, so git th fuk outta th way an gib the man soem rooom. Lionel where u put th plagoon ?.
Cheers Felix' Pruductions
c/o That motr aint fuked till we get nother Karton . 2004.
"Nan & Pop Racing"
Poppy Hops on .... CBR150 (Superlite) CBR954 "Blade"
Nanna Naps on .... MoriWAKI NSR85 (Motolite) ZX10R "Crim"
We may ride like Old Can'ts, But Phuk we look DOOG !!!!!!
Wannabe
Warming up
Warming up
Posts: 99
Joined: Thu Sep 02, 2004 11:59 am
Location: Hobart

Re: re: brakes squealing

Post by Wannabe »

aardvark wrote:My brakes are opposite of that. When I pull them on they feel like they are loose and jumping around all over the place. They also make a grinding noise when I use them.
Sounds to me like your pads might be cooked. You should try deglazing & bedding in the pads (as per Yodas previous post) and if that doesn't fix it, may be time to replace them. I used to have the same problem on my ZZR & 95 ZX6, particularly with some of the SBS pads I'd used. I now use only OEM pads or EBC-HH and I couldn't be happier.
Pontikat wrote:Hey u farllas doen go Fukin wi' Felizx, he alrigh aye, Him top farlla bush canic roun ere, so git th fuk outta th way an gib the man soem rooom. Lionel where u put th plagoon ?.
Cheers Felix' Pruductions
c/o That motr aint fuked till we get nother Karton . 2004.
BWWAAAAHHAHAHAHA :lol: ROFLMAO
Ride Naked!!!
Image
icebreaker
Administrator
Administrator
Posts: 2795
Joined: Wed Apr 07, 2004 7:07 pm
Bike: Z1000
State: Tasmania
Location: Hobart
Contact:

re: brakes squealing

Post by icebreaker »

I want what Brett's smoking...
Ducati Monster S2R1000
Kawasaki '77 Z1000A1, '76 z900 (Project) & '78 Z1000A2 (Project)

http://www.unihost.com.au - Affordable, Reliable Webhostng
Wannabe
Warming up
Warming up
Posts: 99
Joined: Thu Sep 02, 2004 11:59 am
Location: Hobart

re: brakes squealing

Post by Wannabe »

Well whatever he's on, I doubt it's legal.
Make sure you save me some. new_all_coholic.gif
Ride Naked!!!
Image
User avatar
Nanna10r
Team Ninja
Posts: 4291
Joined: Wed Jul 14, 2004 10:42 pm
Bike: ZX10R
State: Queensland
Location: Brisbane Australia

Re: re: brakes squealing

Post by Nanna10r »

icebreaker wrote:I want what Brett's smoking...
What ... Holiday Kings 2mg .... in the Economy Palette ?.

Filthy Habbit !. If it didn't keep my hands out of my Pants at dinner parties I would of given up Years ago.

Cheers Brett
"Nan & Pop Racing"
Poppy Hops on .... CBR150 (Superlite) CBR954 "Blade"
Nanna Naps on .... MoriWAKI NSR85 (Motolite) ZX10R "Crim"
We may ride like Old Can'ts, But Phuk we look DOOG !!!!!!
Post Reply