A qwik question for those with zx7r's or just those with opinions.
how good is the full race 4 into 1 akra system for these?
I have been measuring up to build a custom setup pretty much the same as this. But given the quality of most akrapovics im thinking maybe i might get one of those.
any thoughts?
also can anyone recomend somewhere to buy such a system?
doesnt seem to be anything currently on ebay.
ment
ZX7R Akrapovic
-
- Apprentice Post Whore :-)
- Posts: 7039
- Joined: Wed Apr 21, 2004 8:11 pm
- Location: Sydenham, Victoria
re: ZX7R Akrapovic
i bought my 7r with the full akra system already on it. Not bad but not loud enough.
it depends if u want a brand name with power or noise
it depends if u want a brand name with power or noise

[url]www.rmsmg.com.au
-
- KSRC Contributor
- Posts: 1858
- Joined: Thu May 13, 2004 5:10 pm
- Bike: ZX10R
- State: Queensland
- Location: Ipswich QLD
re: ZX7R Akrapovic
Akra full system $$$$ but Quality !..........those with em on here will give you a good opinion.
I went for a MUZZY full system stainless(not fitted yet) that i got from JC Motors(US Ebay store). My bedroom is starting to look like a spare parts outlet.........exhaust system/bmc filter/factory pro jet kit/+4 factory pro ignition advancer/vortex racing clipons etc etc.
I went for a MUZZY full system stainless(not fitted yet) that i got from JC Motors(US Ebay store). My bedroom is starting to look like a spare parts outlet.........exhaust system/bmc filter/factory pro jet kit/+4 factory pro ignition advancer/vortex racing clipons etc etc.

Glenn
2009 ZX10R
2009 ZX10R
-
- KSRC Member
- Posts: 484
- Joined: Sun Aug 01, 2004 11:17 am
- Bike: ZX9R
- State: Queensland
- Location: wish i was in Brisvegas
Re: re: ZX7R Akrapovic
won't do your bike much good sittin in ya bedroomgreenmeanie wrote:Akra full system $$$$ but Quality !..........those with em on here will give you a good opinion.
I went for a MUZZY full system stainless(not fitted yet) that i got from JC Motors(US Ebay store). My bedroom is starting to look like a spare parts outlet.........exhaust system/bmc filter/factory pro jet kit/+4 factory pro ignition advancer/vortex racing clipons etc etc.

life half lived is no life at all
[url]http://tinypic.com/k85zd.jpeg[/url].
01 ZX9R (Red ofcourse!)
[url]http://tinypic.com/k85zd.jpeg[/url].
01 ZX9R (Red ofcourse!)
re: ZX7R Akrapovic
My ZXR7 runs the titanium muzzy system. They can cause a dead spot below 4000rpm. They are very loud but above 4000rpm they breath really well. I run muzzy cams, bmc filter, opened up carbies / re jetted, big bore kit to 792cc and it took a lot of dyno time to clean up the dead spot. I have one point where it levels between 8000rpm and 8400rpm but its not noticeable while riding. Took off a few hp at the top end to build a better torque figure down low and its now on 125hp at about 11200rpm
They guys who tuned my bike, DynoBike in Victoria, were telling me the muzzy exhaust systems do have that tendency to cause a dead spot down low, although on full throttle they do very well.
Cheers..Clint
They guys who tuned my bike, DynoBike in Victoria, were telling me the muzzy exhaust systems do have that tendency to cause a dead spot down low, although on full throttle they do very well.
Cheers..Clint
- ZX-10R_04
- KSRC Regular
- Posts: 762
- Joined: Wed Aug 11, 2004 11:18 pm
- Bike: ZX10R
- State: Tasmania
- Location: Launceston Tasmania
- Contact:
re: ZX7R Akrapovic
If It Aint A Lime It Must Be A Lemon !!!!
04 ZX10R & 08 ZX10R
04 ZX10R & 08 ZX10R
- mike-s
- Apprentice Post Whore :-)
- Posts: 6142
- Joined: Sat Aug 07, 2004 5:43 am
- Bike: Suzuki
- State: New South Wales
- Location: Arncliffe, Sydney
- Contact:
re: ZX7R Akrapovic
sweet merciful crap, that is one HELL of a website update that they had recently!